Back to Blog
How-to Guides 2026-11-20 Zpacks | Level Up Your Next Adventure 0 views

How to Use Stick on Flat Loop for Gear Attachments

How to Use Stick on Flat Loop for Gear Attachments

Learn how to add light-duty attachment points to your Dyneema Composite Fabric gear using the Zpacks Stick on Flat Loop. Simple peel-and-stick installation.

What the Stick on Flat Loop Does

The Zpacks Stick on Flat Loop is a small Dyneema Composite Fabric patch with a sewn loop and adhesive backing. It lets you add a light-duty attachment point wherever you need one — on a tarp, stuff sack, backpack, or other gear. Just peel off the brown paper backing and press it into place.

Stick on Flat Loop Details

  • Stick on Flat Loop: This Dyneema Composite Fabric patch has a loop sewn to it and tape adhesive on the back. Peel off the brown paper back and stick it where you need it. Installation takes seconds and requires no tools or sewing.
    Stick on Flat Loop
    Stick on Flat Loop
  • Stick on Flat Loop: These stick excellent to Dyneema Composite Fabric gear, but they will not stick to silicone fabrics. The adhesive will stick OK to normal nylon or polyester. Knowing what surfaces work best helps you avoid a failed bond. Stick to DCF for the strongest hold.
  • Stick on Flat Loop: You can use this to add light-duty attachment points to your gear, or add hang loops to your tarp. This is not a load-bearing repair item — it is meant for light-duty tasks like hanging a tarp or clipping a small accessory.

How to Attach a Stick on Flat Loop

  1. Choose the right surface: For the strongest bond, apply the flat loop to Dyneema Composite Fabric. It will also stick OK to standard nylon or polyester, but avoid silicone-coated fabrics — the adhesive will not hold.
  2. Clean and dry the area: Make sure the target surface is clean and dry. Dirt or moisture can prevent the adhesive from bonding properly.
  3. Peel off the brown paper backing: The adhesive is covered by a brown paper sheet. Remove it to expose the sticky side of the patch.
  4. Press firmly into place: Position the patch where you want it and press down firmly over the entire surface. The loop should be oriented so it points in the direction you need for your attachment.
  5. Wait before loading: Give the adhesive a moment to set before attaching anything. The bond strengthens over time, especially on DCF surfaces.

What the Stick on Flat Loop Is Not For

The flat loop is intended for light-duty use — think hanging a tarp loop or clipping a small carabiner. It is not designed to bear heavy loads or replace sewn attachment points. If you need a load-bearing repair, a sewn solution or a dedicated hardware replacement is more appropriate.

Also, remember the adhesive will not stick to silicone-impregnated fabrics. If your gear has a silicone coating, the flat loop will not bond and will eventually peel off.

Related Articles

Customer Service
Home
Products
Cart
Profile